Crosby 1/2″ S-421T TERMINATOR Wedge Socket with Round Pin & Cotter

Crosby S-421T TERMINATOR Wedge Sockets have an efficiency rating of 80% based on the catalog strength of XXIP wire rope. The TERMINATOR design secures the tail or “dead end” of the wire rope to the wedge, thus eliminating loss or “Punch out” of the wedge as well. It also eliminates the need for an extra piece of rope, and potential for the tail to break off due to fatigue. The tail, which is secured by the base of the clip and the wedge, is left undeformed. As an added safety feature, the S-421T TERMINATOR Wedge Socket incorporates Crosby’s patented QUIC-CHECK® “Go” and “No-Go” feature cast into the wedge. The proper size rope is determined when the following criteria are met:
1) The wire rope should pass thru the “Go” hole in the wedge.
2) The wire rope should NOT pass thru the “No-Go” hole in the wedge.
Crosby S-421T TERMINATOR Wedge Sockets meet or exceed all requirements of ASME B30.26 including identification, ductility, design factor, proof load and temperature requirements. Importantly, these sockets meet other critical performance requirements including fatigue life, impact properties and material traceability, not addressed by ASME B30.26.

• Equipped with Round Pin & Cotter
• Fits Wire Rope Size: 1/2″
• Replacement Wedge: 307-1035564